Started to Cover the Seats!

I got started on covering the seats with 4 out of the 10 pieces I need to do having been completed. Lots of work left to do, but so far I am pretty pleased with the final product not that I have it.

More pictures to follow as they are completed!

Seat Covers Are Here!

I was beginning to think this day would never come, but the seat covers arrived this afternoon. After a quick inspection they look good.  Some errant black marks in places that look like they will clean off easily enough, but good.

Now starts the process of recovering the seats. Hopefully this will go smoothly without any issues on fit or workmanship. I'll post some pictures soon...

Heads Are Back...

The heads are back from the machine shop and after I wipe them down and give them a quick coat of paint, they will be ready for installation.

I had the combustion surfaces cleaned up, had a valve job done, the springs tested, shimmed and installed, and new valve stem seals added. $247 seemed like a very reasonable price to me.

I can almost hear the starter cranking the engine ...

Delayed again, but ...

Well, the 5th slipped to the 6th, but the covers are now on their way here. Looks like Monday and I will finally be able to get started on covering the seats.

So, I finally had to get around to prepping them for new covers. This means reapplying the burlap with wire supports. I have found rear seats and bench seats can be an excellent source for large, very clean, original pieces to do your seats. A few hog nose rings and they were ready to cut. Using the hog nose ring cutters that I have to trim the steel wires, I followed the perimeter trimming them, then floowed back up with scissors for the burlap.

On to the opposite side and repeat.

And before the foam can go on, I add a perimeter of 2" thick poly roll cut in roughly 3" wide strips. These will help prevent the covers from being torn by the frame and distribute some of the pressure so they will look smoother along that edge.

Good news is, I shouldn't really have to do much of anything with the middle or third row seats. Hopefully more to post on Monday!

Light at the end of the tunnel?

After yet another delay, I have finally been given a date for the seat covers: September 5th! With any amount of luck, I will have them back here that weekend and I can FINALLY finish up the seats.

While waiting I have finished up porting the heads and sent them off to the machine shop to prep them for installation. I have also finished the driver's side header and will hopefully knock out the passenger's side before the seat covers get back. Starting to feel like I might hear the motor run soon...

More to come as I have it ready.